LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> ATS V, 4D Sedan, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LGX LF4) - Repair Instructions >> Repair Instructions >> Oil Pump Flow Control Solenoid Valve Harness Replacement >> Installation Procedure

Installation Procedure

  1. GM4260770Courtesy of GENERAL MOTORS COMPANY

    Using the mechanics wire, guide the oil pump flow control solenoid valve harness (3) into place, then remove the wire.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Oil Pump Flow Control Solenoid Valve Harness Bolt (2) - Install and tighten 15 N.m (11 lb ft)
  3. Engine Wiring Harness (1) - Connect
  4. GM4260746Courtesy of GENERAL MOTORS COMPANY

    Oil Pump Flow Control Solenoid Valve Harness (1) @ Crankshaft Oil Deflector (4) - Install

  5. Oil Pump Flow Control Solenoid Valve Harness (1) @ Retainer (3) - Install
  6. Oil Pump Flow Control Solenoid Valve Harness (1) @ Oil Pump Flow Control Solenoid Valve (2) - Connect
  7. Lower Oil Pan Replacement (AWD)Lower Oil Pan Replacement (RWD) - Install
  8. Front Compartment Lower Noise Shield Replacement (All Wheel Drive)Front Compartment Lower Noise Shield Replacement (Rear Wheel Drive) - Install
scientia non olet · About LEMON Manuals