Installation Procedure
Multifunction Energy Storage Capacitor (3) - Install
- Multifunction Energy Storage Capacitor Fastener (1) - Tighten [2x] to 9 N.m (80 lb in)
- Electrical Connector (2) - Connect
Auxiliary Generator Battery Jumper Cable (3) - Install
- Auxiliary Generator Battery Jumper Cable Nut (2) - Tighten 12 N.m (106 lb in)
- Ground Cable (5) - Install
- Ground Cable Nut (4) - Tighten 12 N.m (106 lb in)
- Protective Cap (1) - Install
- Rear Bumper Fascia Replacement - Install
- Lower the vehicle.
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection
- Perform Stop/Start Capacitor Control State Health Reset. Stop/Start Capacitor Control State of Health Reset
CAUTION:
Refer to Fastener Caution .