Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Rear Axle Bolt | |
|
90 N.m (66 lb ft) |
|
90-105 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Differential Clutch Bolt | 30 N.m (22 lb ft) |
| Differential Clutch Cover Bolt | 6 N.m (53 lb in) |
| Rear Differential Clutch Control Module Bolt | 6 N.m (53 lb in) |
| Limited Slip Differential Clutch Pipe Connector | 7 N.m (62 lb in) |
| Differential Clutch Oil Inspection Plug | 14 N.m (10 lb ft) |
| Differential Clutch Pump Bolt | 6 N.m (53 lb in) |
| Limited Slip Differential Clutch Valve Housing | 3 N.m (27 lb in) |
| Rear Axle Housing Drain Plug | 33 N.m (24 lb ft) |
| Rear Axle Housing Fill Plug | 33 N.m (24 lb ft) |
| Propeller Shaft Flange Nut | 100 N.m (74 lb ft) |
| Rear Axle Bolt- Front | 125 N.m (92 lb ft) |