LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> CTS Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 (Electronic Suspension Control System) >> Repair Instructions >> Electronic Suspension Front Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the level sensor stud (2) into the slot in frame rail (3) slide it toward the engine.
    Fig 1: Level Sensor Nut, Level Sensor Positioning Stud And Frame Rail
    GM3470945Courtesy of GENERAL MOTORS COMPANY
    NOTE: Ensure that the level senor is properly seated on the frame rail.
  2. Tighten the level senor nut (1) to 9 N.m (80 lb in).
    CAUTION: Refer to Fastener Caution
  3. Install the level sensor link (1) on the lower control arm ball stud (2).
    Fig 2: Level Sensor Link And Lower Control Arm Ball Stud
    GM3470939Courtesy of GENERAL MOTORS COMPANY
  4. Reconnect the level sensor electrical connector (1) to the electronic level sensor.
    Fig 3: Electrical Connector
    GM3470931Courtesy of GENERAL MOTORS COMPANY
  5. Install the right front wheel house liner. Refer to Front Wheelhouse Liner Replacement (Non V-Series) and Front Wheelhouse Liner Replacement (V-Series) .
  6. Remove the support and lower the vehicle.
  7. Reprogram the level sensor.
scientia non olet · About LEMON Manuals