Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Suspension Lower Control Arm (2)» Install
CAUTION: Refer to Fastener Caution
- Install the electronic suspension rear position sensor ball stud (1) and tighten to 7 N.m (62 lb in).
- Install the rear suspension lower control arm inner nut (1) and bolt (2). Do not tighten at this time.
- Rear Suspension Lower Control Arm Bolt (2) Install a NEW bolt.CAUTION: When removing/installing the lower control arm bolt, use care to not damage the park brake cable housing. If the housing is damaged, park brake failure may occur
- Rear Suspension Lower Control Arm Nut (1)» Install
Tighten the Bolt
First Pass: 150 N.m (111 lb ft)
Final Pass: plus 90-105 degrees
- Rear Suspension Lower Control Arm Inner Nut» Tighten
Tighten
First Pass: 115 N.m (85 lb ft)
Final Pass: plus 90-105 degrees
- Install the NEW rear shock absorber lower bolt (1).
WARNING: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fasteners could cause damage to the vehicle, component or bodily injury.
Tighten
First Pass: 115 N.m (85 lb ft)
Final Pass: plus 90-105 degrees
- Install the electronic suspension rear position sensor linkage. Refer to Electronic Suspension Rear Position Sensor Replacement
- Rear Suspension Lower Control Arm Cover (2)» Install - Rear Suspension Lower Control Arm Cover Replacement
- Install the rear wheel. Refer to Tire and Wheel Removal and Installation (October 4th 2015 and Earlier) and Tire and Wheel Removal and Installation (October 5th 2015 and Later)
- Remove the safety stands.
- Lower the vehicle to the ground.
- Perform rear camber adjustment. Refer to Rear Camber Adjustment