Diagnostic Aids
The following is a brief description of potential causes which may aid in diagnosis:
- Manual Disable - The parking assist system has been disabled through the parking assist switch.
- Hitch/Object Attached - The parking assist control module is detecting an object that is attached to the vehicle. Common items such as a hitch receiver, trailer or a bicycle rack may cause this concern. Additionally, damage to the rear of the vehicle or a misaligned sensor may cause this concern. If the vehicle is damaged in a manner that causes the sensor to detect the fascia itself, the parking assist control module will interpret this as an attached object and disable the system. Carefully inspect the fascia, fascia mounting surface and sensor retainers before continuing with normal diagnosis. After the detected cause has been addressed the vehicle must be driven at speed greater than 40 km/h (25 mph).
- Vehicle Overspeed - The vehicle is travelling too fast in reverse at speeds of greater than 8 km/h (5 mph).
- Inhibit - The parking assist control module has lost or received invalid GMLAN signal(s).
- Sensor Disturbance - An outside interference is causing sensor movement. Such interference may be caused a heavy pounding, like that of a nearby jackhammer or large changes in pressure, such as a large truck air brakes.
- Sensor Ring Time - If the sensor fails its own diagnostic initialization the parking assist control module will set this error. After the detected cause has been addressed the vehicle must be driven at speed greater than 40 km/h (25 mph). The following is a list of reasons this cause may have set:
- One or more of the sensors may be blocked by snow, mud, ice or other debris. This might happen after going through a car wash in cold weather.
- Silicone insulator surrounding sensor maybe missing, cut or twisted.
- Improperly installed sensor, sensor maybe be crooked due to a tight wire harness.
- One or more of the sensors may be scratched or the paint maybe chipped.
- Excessive paint thickness on a sensor may cause an excessive sensor ring time. When replacing or refinishing a sensor, do not apply an excessive amount of paint or clear coat.