Removal Procedure
WARNING: This page is about a different car, the 2016 Cadillac CT6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
CAUTION:
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Place the ignition switch in the OFF position.
- Engine Wiring Harness Fuse Block Bracket » Remove — Engine Wiring Harness Fuse Block Bracket Replacement
- Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
- Disconnect the EBCM electrical connector.
- Disconnect Brake Pressure Modulator Valve Primary Brake Pipe Fitting (1)
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
- Remove Electronic Brake Control Module Bolt (1).
- Remove Electronic Brake Control Module (1)