LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> ATS V, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LGX LF4) - Repair Instructions >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement (LF4) >> Removal Procedure

Removal Procedure

  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static)Cooling System Draining and Filling (GE 47716)
  2. Remove Plenum Front Panel. Refer to Plenum Front Panel Replacement
  3. Remove Engine Rear Noise Shield. Refer to Engine Rear Noise Shield Replacement (LF4) 
  4. Disconnect the Fuel Feed Pipe - Fuel Tank to Engine from the Fuel Feed Pipe - at Engine and reposition. Refer to Fuel Feed Pipe Replacement (Fuel Tank To Engine LF4) Fuel Feed Pipe Replacement (LF4 at Engine) 
    5. Fig 1: Engine Coolant Temperature Sensor Electrical Connector And Fasteners
    GM4036024Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect Engine Coolant Temperature Sensor Electrical Connector (1)
  6. Remove Engine Coolant Temperature Sensor Fastener (2) (Qty: 2)
    7. Fig 2: Engine Coolant Temperature Sensor And Retainer
    GM4036066Courtesy of GENERAL MOTORS COMPANY
  7. Remove Engine Coolant Temperature Sensor Retainer (1)
  8. Remove Engine Coolant Temperature Sensor (2)
    9. Fig 3: Engine Coolant Temperature Sensor Seal
    GM4036113Courtesy of GENERAL MOTORS COMPANY
  9. Remove and DISCARD Engine Coolant Temperature Sensor Seal (1)
scientia non olet · About LEMON Manuals