Installation Procedure
WARNING: This page is about a different car, the 2016 Cadillac CT6. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the brake caliper pins and brake pad spring for damage or excessive corrosion and replace, if necessary.
- Install Disc Brake Pad (1)
- Install Brake Pad Spring (1)
- Install Brake Caliper Pin (1)
- Carefully drive the brake caliper pins into the brake caliper until fully seated.
- With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 6-7 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
- Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Master Cylinder Reservoir Filling
- Burnish the brake pads and rotors. Brake Pad and Rotor Burnishing