Installation Procedure
- Install Battery Positive Cable (2)
- Install Battery Positive Cable Nut (1) and tighten 15 N.m (11 lb ft)
- Install Power Distributor Fuse Block Cover (1)
- Engage Retainer (1)
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Engage Retainer (1)
- Engage Retainer (1)
- Secure the clips.(2)
- Install the auxiliary A/C evaporator tube bracket fastener. (3) and tighten 9 N.m (80 lb in)
- Install Power Distributor Fuse Block Cover (1)
- Engage Retainer (1)
- Lower the vehicle.
- Feed the battery positive cable through rear compartment opening.
- Install Rubber Grommet (2)
- Engage Retainer (1)
- Battery Positive Cable (2)
- Engage Retainer (3)
- Install Battery Positive Cable Nut (1) and tighten 15 N.m (11 lb ft)
- Install Battery Distribution Fuse Block Cover (2)
- Engage Battery Distribution Fuse Block Cover Retaining Tab (1)
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection
- Install Spare Tire (2)
- Hand tighten Spare Tire Stowage Retainer (1)
- Install Rear Compartment Floor Panel Trim Rear Compartment Floor Panel Trim Replacement
CAUTION:
Refer to Fastener Caution