LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2016 >> ATS Base, 2D Coupe, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Multifunction Energy Storage Capacitor Control Module Replacement (KL9) >> Installation Procedure

Installation Procedure

    Fig 1: Multifunction Energy Storage Capacitor Control Module
    GM4087156Courtesy of GENERAL MOTORS COMPANY
  1. Multifunction Energy Storage Capacitor Control Module - Install
    2. CAUTION:

    Refer to Fastener Caution .

  2. Multifunction Energy Storage Capacitor Control Module Nut - Install and tighten Install and tighten 9 N.m (80 lb in)
    3. Fig 2: Auxiliary Generator Battery Jumper Cable
    GM4087151Courtesy of GENERAL MOTORS COMPANY
  3. Auxiliary Generator Battery Jumper Cable - Install <p01>
  4. Auxiliary Generator Battery Jumper Cable Nut - Install and tighten 12 N.m (106 lb in)
  5. Connect the electrical connectors.
    6. Fig 3: Multifunction Energy Storage Capacitor Control Module
    GM4087148Courtesy of GENERAL MOTORS COMPANY
  6. Multifunction Energy Storage Capacitor Control Module Bracket - Install
  7. Multifunction Energy Storage Capacitor Control Module Bracket Bolt
  8. Install and tighten to 9 N.m (80 lb in.)
    9. Fig 4: Active Safety Control Module
    GM4262463Courtesy of GENERAL MOTORS COMPANY
  9. { If equipped }Active Safety Control Module Bracket - Install
  10. { If equipped } Active Safety Control Module Bracket Bolt - Install and tighten 2.5 N.m (22 lb in)
  11. Rear Compartment Side Trim Replacement - Left Side (Sedan with AM9)Rear Compartment Side Trim Replacement - Left Side (Sedan except AM9)Rear Compartment Side Trim Replacement - Left Side (Coupe) -Install
  12. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection .
  13. Perform Stop/Start Capacitor Control State Health Reset. Stop/Start Capacitor Control State of Health Reset 
scientia non olet · About LEMON Manuals