Approximate Fluid Capacities

The following approximate capacities are given in US English and metric conversions. See Fluid and Lubricant Recommendations for more information. All capacities are approximate. When adding, be sure to fill to the approximate level, as recommended in this manual. Recheck fluid level after filling.

Application	Specification
Application	Metric	US English
Engine Cooling System
2.0L	7.6 liters	8.0 quarts
2.5L	6.6 liters	7.0 quarts
3.6L	10.2 liters	10.8 quarts
Engine Oil - 2.0L (LTG) or 2.5L (LCV)
Oil Capacity - 2WD	4.7 liters	5.0 quarts
Oil Capacity - AWD	5.7 liters	6.0 quarts
Engine Oil - 3.6L (LFX)
Oil Capacity - with Filter	5.7 liters	6.0 quarts
Oil Capacity - without Filter	5.2 liters	5.5 quarts
Hydraulic Brakes
Hydraulic Brake System	0.43 liters	0.99 pints
Transfer Case
Transfer Case Fluid - Mobil LT	0.78 liters	0.80 quarts
Manual Transmission
DEXRON®VI P/N 88861037 (Canadian P/N 19264717) When filled, fluid level should be at the bottom of the fluid check plug hole.	2.7 liters	2.83 quarts
Automatic Transmission Fluid
Pan Removal and Filter Replacement - Approximate Capacity	6.0 liters	6.4 quarts
Overhaul - Approximate Capacity	9.5 liters	10.1 quarts
Complete Trans System - Approximate Capacity	10.3 liters	10.8 quarts
Refrigerant System Capacities
Abrupt Refrigerant Loss	60 ml¹	2.0 oz¹
Compressor Replacement
NOTE: Compressor failure can occur if the oil removed during refrigerant recovery is not replaced. The service compressor is pre-charged with one of the following specified amounts of PAG oil. Refer to the instruction sheet included with the service compressor.	41 ml²	1.4 oz²
Condenser Replacement	30 ml²	1.0 oz²
Evaporator Replacement	90 ml²	3.0 oz²
Any Line Set (Hose/Tube or Tube assembly) Replacement	30 ml²	1.0 oz²
Total System PAG Oil Capacity	120.0 ml	4.1 oz
R-134a
Refrigerant Charge	0.55 kg	1.2 lb
¹ Abrupt refrigerant loss due to large leak, hose rupture, collision, or pressure relief valve opening. Conditions that allow the refrigerant to seep or bleed off over time do not cause this oil loss. Upon replacement of a component that caused a large refrigerant loss, also add the required amount of oil for the particular component. ² If more than the specified amount of PAG oil was drained from a component, add the amount drained.