Inside Rearview Mirror Bracket Installation
- Determine the location of the mirror mounting base by marking the outside/inside of the windshield with a wax pencil where the base was previously located. If it is not clear where the base was located, use the following steps to determine where the base should be installed:
- Using a measuring tape, measure the distance between the windshield pillars at the windshield blackout line.
- Using a marking pencil, halfway between the windshield pillars, draw a centerline (1) on the windshield from the roof panel to the windshield base.
- Draw a perpendicular line intersecting the centerline (2) at that location.
The bottom center of the mirror mounting base will be at the intersection of these lines.
- Clean the inside windshield glass thoroughly to remove all old adhesive.
- Clean mirror mounting base thoroughly to remove all of the old adhesive.
- Using the Inside Mirror Adhesive Kit , or equivalent to apply a small amount of activator to the mounting surface of the mirror mounting base. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Apply a small amount of activator to the windshield where the mounting base is to be installed.
- Allow the activator to dry 5 minutes.
- Apply 1 drop of adhesive to the center of the mirror mounting base.
- Immediately apply the mounting base to the windshield, ensuring that the mounting base aligns correctly to the marks made on the outside of the windshield.
- Hold the mounting base firmly in place for 1 minute.
- Allow the adhesive to set for 15 minutes before installing the rearview mirror.
- Clean the wax pencil lines from the exterior surface of the glass.
- Install the mirror to the mirror mounting base. Refer to Inside Rearview Mirror Replacement .
NOTE:
If the windshield is equipped with a blackout area around the mirror base bracket Care Must be used not to cut or scrape the blackout .
NOTE:
Clean the inside windshield glass and the mounting surface of the mirror mounting base thoroughly with a clean cloth saturated with naphtha or a 50/50 mixture by volume of clean water and isopropyl alcohol.
NOTE:
If reinstalling the original mounting base, place the mirror mounting base in a suitable holding device, such as a vice.
NOTE:
Do not touch the mounting surface of the mirror mounting base or the glass.