LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2014 >> ELR >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Removal Procedure

Removal Procedure

  1. Remove the rear floor stowage compartment. Refer to Rear Compartment Floor Stowage Trim Compartment Replacement .
  2. Disconnect the battery negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
    3. Fig 1: Battery Fuse Box Flap & Retaining Tabs
    GM2595433Courtesy of GENERAL MOTORS COMPANY
  3. Unlock the retaining tab (2) on the battery fuse box cover.
  4. Open the battery fuse box flap (1).
    5. NOTE:

    Pull the battery fuse box housing. DO NOT pull the flap.

  5. Unlock the retaining tab (3) and open the battery fuse box cover.
    6. Fig 2: Battery Positive Cable Fuse Block Nut And Terminal
    GM2374800Courtesy of GENERAL MOTORS COMPANY
  6. Remove the battery positive cable fuse block nut (1) and terminal (2) from the battery fuse block.
  7. Remove the quarter inner trim finish panel.
  8. Separate the battery positive cable from the body harness, while working from the rear compartment towards the passenger compartment.
    9. Fig 3: Battery Positive Cable
    GM2374799Courtesy of GENERAL MOTORS COMPANY
  9. Remove the rear side door floor covering retainer. Refer to INTERIOR TRIM AND INTERIOR PANELING .
  10. Detach the battery positive cable (1) from the rear passenger compartment.
    11. Fig 4: Battery Positive Cable And Left Rocker Channel
    GM2374795Courtesy of GENERAL MOTORS COMPANY
  11. Remove the interior trim panels (1).
  12. Remove the battery positive cable (2) from the left rocker channel.
    13. Fig 5: Battery Positive Terminal, Engine Wiring Junction Block And Nut
    GM2374796Courtesy of GENERAL MOTORS COMPANY
  13. Detach the battery positive terminal (2), from the engine wiring junction block (3), with the nut (1).
  14. Remove the electronic brake control module with brake pressure modulator valve (BPMV). Refer to Electronic Brake Control Module with Brake Pressure Modulator Valve Replacement
    15. Fig 6: Wiring Harness Grommet
    GM2374797Courtesy of GENERAL MOTORS COMPANY
  15. Pull the battery positive cable (2) through the harness grommet (1).
  16. Remove the battery positive cable from the vehicle.
scientia non olet · About LEMON Manuals