Rear Toe Adjustment
- Measure the alignment on an alignment rack. Refer to Wheel Alignment Measurement .
- Remove the rear suspension adjust link nut (2).
- Remove and discard the rear suspension adjust link bolt (1). DO NOT reuse. Replace with NEW only.
- Rotate the rear suspension adjust link bolt (1) until the proper toe measurement is achieved. Refer to Wheel Alignment Specifications .
- Hold the adjust link bolt (1) and tighten the nut (2) enough to maintain the adjustment.
- Check the alignment specification and readjust if needed.
- Hold the NEW rear suspension adjust link bolt (1) and tighten the rear suspension adjust link nut (2) to
-
- First Pass: 70 (52 lb ft)
- Final Pass: plus 90 degrees
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:
Refer to Fastener Caution .
NOTE:
It will be necessary to replace the torque to yield bolt if they are torqued to specification and then loosened.