LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2014 >> ATS Base, 2.0L Eng VIN X, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Removal Procedure

Removal Procedure

  1. Remove the left side rear compartment trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side (With AM9) , Rear Compartment Side Trim Replacement - Left Side (Except AM9) .
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Open the battery fuse block cover.
    4. Fig 1: Battery Positive Cable, & Fuse Block
    GM3752796Courtesy of GENERAL MOTORS COMPANY
  4. Remove the battery positive cable fastener (1) from the battery fuse block (2) and remove the battery positive cable (3).
    5. Fig 2: Battery Positive Cable & Retainers
    GM3752799Courtesy of GENERAL MOTORS COMPANY
  5. Detach the battery positive cable retainers (1) from the rear compartment area.
  6. Remove the rear seat cushion. Refer to Rear Seat Cushion Removal and Installation .
  7. If equipped with AM9, remove the seat back bolster. Refer to Rear Seat Back Bolster Replacement .
  8. If equipped with AM9, remove the rear seat back cushion. Refer to Rear Seat Back Cushion Removal and Installation (40% Seat with AM9) , Rear Seat Back Cushion Removal and Installation (60% Seat with AM9) , Rear Seat Back Cushion Removal and Installation (without AM9) .
  9. Remove the rear side door sill garnish moldings left and right. Refer to Rear Side Door Sill Garnish Molding Replacement .
    10. Fig 3: Battery Positive Cable
    GM2827718Courtesy of GENERAL MOTORS COMPANY
  10. Remove the battery positive cable from inside the conduits (1).
  11. Peal back the rear carpet to access the battery positive cable in front of the rear seat.
    12. Fig 4: Battery Positive Cable Retainers
    GM2827721Courtesy of GENERAL MOTORS COMPANY
  12. Detach the battery positive cable retainers (1) .
  13. Remove the passenger seat. Refer to Driver or Passenger Seat Removal and Installation .
  14. Remove the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
  15. Remove the rear side door sill garnish molding. Refer to Rear Side Door Sill Garnish Molding Replacement .
  16. Remove the right side instrument panel lower trim panel insulator. Refer to Instrument Panel Lower Trim Panel Insulator Replacement (Left Side) , Instrument Panel Lower Trim Panel Insulator Replacement (Right Side) .
  17. Remove the front side door sill trim plate. Refer to Front Side Door Sill Trim Plate Replacement .
  18. Remove the body control module. Refer to Body Control Module Replacement .
  19. Peel back the carpet to access the battery positive cable.
    20. Fig 5: Battery Positive Cable Retainers
    GM2827724Courtesy of GENERAL MOTORS COMPANY
  20. Detach the battery positive cable retainers (1).
    21. Fig 6: Pre-Fuse Block
    GM2827728Courtesy of GENERAL MOTORS COMPANY
  21. Remove the following from the pre-fuse block:
    22. Fig 7: Battery Positive Cable Retainers
    GM3752802Courtesy of GENERAL MOTORS COMPANY
  22. For Sedan, detach the battery positive cable retainers (1) from the radiator surge tank and the right wheelhouse.
    23. Fig 8: Battery Positive Cable Retainers (Coupe)
    GM3752804Courtesy of GENERAL MOTORS COMPANY
  23. For Coupe, detach the battery positive cable retainers (1) from below the brake pressure modulator valve.
  24. Remove the plenum front panel. Refer to Plenum Front Panel Replacement .
    25. Fig 9: Battery Positive Cable, Retainers & Pass Through Grommet
    GM2827737Courtesy of GENERAL MOTORS COMPANY
  25. Remove the pass through grommet (1) and detach the battery positive cable retainers (3).
  26. Pull the battery positive cable (2) through the pass through opening.
  27. Remove the battery positive cable from inside the vehicle.
scientia non olet · About LEMON Manuals