LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> SRX Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Wheel Speed Sensor Electrical Connector
    GM2217497Courtesy of GENERAL MOTORS COMPANY
  1. Install the wheel speed sensor connector retainer to the rear suspension cradle.
  2. Connect the wheel speed sensor electrical connector (1).
    3. Fig 2: Wheel Speed Sensor Harness Retainers
    GM2217496Courtesy of GENERAL MOTORS COMPANY
  3. Install the wheel speed sensor harness to the retainers (1).
    4. Fig 3: Wheel Speed Sensor
    GM2217495Courtesy of GENERAL MOTORS COMPANY
  4. Install the wheel speed sensor (1) to the rear suspension knuckle.
    5. Fig 4: Wheel Speed Sensor Bolt
    GM2217494Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  5. Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
  6. Install the rear suspension link. Refer to Rear Suspension Link Replacement - Upper to Lower Control Arm .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals