LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 883 (Adjustable Pedal System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the aid of an assistant, position the brake booster to the vehicle.
    2. Fig 1: View Of Adjustable Pedal Bracket Bolt
    GM1892149Courtesy of GENERAL MOTORS CORP.
  2. Install the adjustable pedal assembly to the vehicle.
    3. IMPORTANT: Do not tighten the adjustable pedal bracket bolt until the adjustable pedal bracket nuts are installed.
  3. Hand install the adjustable pedal bracket bolt (1).
    4. NOTE: Refer to Fastener Notice .
    Fig 2: Locating Adjustable Pedal Bracket Nuts
    GM1892147Courtesy of GENERAL MOTORS CORP.
  4. Install the adjustable pedal bracket nuts (1).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  5. Tighten the adjustable pedal bracket bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    6. Fig 3: View Of Stoplamp Switch
    GM1892146Courtesy of GENERAL MOTORS CORP.
  6. Connect the brake booster pushrod from the brake pedal pivot.
  7. Install the stoplamp switch (1).
    8. Fig 4: Locating Brake Booster Pushrod Retainer
    GM1892145Courtesy of GENERAL MOTORS CORP.
  8. Install the brake booster pushrod retainer (1).
    9. Fig 5: Locating Brake Booster Pushrod Retainer Bolt
    GM1892143Courtesy of GENERAL MOTORS CORP.
  9. Install the brake booster pushrod retainer bolt (1).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  10. Install the accelerator pedal position sensor assembly. Refer to Accelerator Pedal Position Sensor Replacement .
  11. Connect the electrical connectors to the following components:
    • The adjustable pedals motor assembly
    • The memory sensor connector, if equipped
    • The pedal position sensor
    12. Fig 6: View Of Bolt Securing Selector Cable To Brace
    GM394467Courtesy of GENERAL MOTORS CORP.
  12. Install the transmission range selector cable support bolt to the I/P reinforcement brace.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  13. Install the steering column to the vehicle. Refer to Steering Column Replacement .
  14. Install the left side floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side .
  15. Install the master cylinder to the brake booster.
  16. Install the 2 master cylinder nuts.

    Tighten:  Tighten the nuts to 33 N.m (24 lb ft).

  17. Verify the correct operation of the adjustable pedals.
scientia non olet · About LEMON Manuals