LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the washer pump to the new washer solvent container.
  2. Install the washer solvent container cap.
    Fig 1: Installing Washer Pump
    G02422371Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the washer pump.
  4. Remove the cap on the washer pump and connect the washer hose to the washer pump.
  5. Position the washer solvent container into the locating holes in the chassis.
    Fig 2: Connecting Electrical Connector & Washer Hose
    G02422372Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to FASTENER NOTICE .
  6. Install the washer solvent container with the bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

  7. Install the upper fender support bar.
  8. Fill the washer solvent container.
  9. Close the hood.
    Fig 3: Installing Washer Solvent Container With Bolt
    G02422373Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals