LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft link insulators and spacers.
  2. Perform the following procedure before installing the stabilizer shaft link bolts.
    1. Remove all traces of the original adhesive patch.
    2. Apply Threadlocker GM P/N 12345382 or BLUE LOCTITE™ #242 on the threads of the bolts.
  3. Install the stabilizer shaft link bolts.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  4. Install the stabilizer shaft nut to the link bolt.

    Tighten 

    Tighten the bolt to 11 N.m (97 lb in).

  5. Remove the safety stands
  6. Lower the vehicle.
    Fig 1: Installing Stabilizer Shaft Nut, Link Bolt, Insulators and Spacers
    G01269650Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals