LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1622 (Front Drive Axle) >> Repair Instructions >> Front Drive Axle Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Actuator & Components
    GM1690919Courtesy of GENERAL MOTORS CORP.
  1. Apply sealant to the threads of the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.25 inch axle (4). Use the correct sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers .
    2. CAUTION: Refer to Fastener Caution .
  2. Install the actuator (1 or 3).

    Tighten:  Tighten the actuator to 20 N.m (15 lb ft).

  3. Connect the electrical connector to the actuator.
  4. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals