LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1214 (Front Suspension System) >> Repair Instructions >> Upper Control Arm Replacement (2500) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm.
    2. Fig 1: View Of Upper Control Arm & Components
    GM793281Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the upper control arm bolts.

    Tighten:  Tighten the nuts to 190 N.m (140 lb ft).

  3. Connect the upper control arm to the steering knuckle.
  4. Install the new nut to the upper ball joint stud.

    Tighten:  Tighten the nut to 50 N.m (39 lb ft).

  5. Install the retaining bolts for the brake hose and wheel speed sensor brackets.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
  8. Verify the wheel alignment. Refer to Wheel Alignment Specifications .
scientia non olet · About LEMON Manuals