LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1028 (Object Detection System) >> Diagnostic Information and Procedures >> Information Center Telltale Malfunction >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Rear Parking Assist Malfunction

  1. Ignition OFF, disconnect the harness connector at the RPA display.
  2. Ignition ON, verify that a test lamp illuminates between the 12V voltage supply circuit terminal 1 and ground.
    • If the test lamp does not illuminate, test the voltage supply circuit terminal for a short to ground or an open/high resistance.
  3. Connect a test lamp between the control circuit and the 12V voltage supply circuit terminal 1 of the appropriate LED listed below:
    • Left amber LED control circuit terminal 2
    • Center amber LED control circuit terminal 3
    • Red LED control circuit terminal 4
  4. Command the appropriate LED ON and OFF with a scan tool, verify that a test lamp turns ON and OFF when switching between commanded states.
    • If the test lamp does not illuminate, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the object alarm module.
    • If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, test or replace the object alarm module.
  5. If all circuits test normal, test or replace the RPA display.

Rear Parking Assist Disable Switch Malfunction

  1. Ignition OFF, disconnect the I/P multifunction switch assembly.
  2. Test for less than 1.0 ohm between ground circuit terminal 3 and ground.
    • If greater than the specified range, test the ground circuit for a short to voltage or an open/high resistance.
  3. Ignition ON, transmission in REVERSE, verify that the scan tool Park Assist System Status parameter is Enable.
    • If not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, test or replace the object alarm module.
  4. Connect a 10A fused jumper wire between signal circuit terminal 2 and ground.
  5. Ignition ON, transmission in REVERSE, verify that the scan tool Park Assist System Status parameter is Disable.
    • If not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, test or replace the object alarm module.
  6. If all circuits test normal, test or replace the I/P multifunction switch assembly.
scientia non olet · About LEMON Manuals