LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> STS AWD >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Tilt Motor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Tilt Cable Assembly
    GM626492Courtesy of GENERAL MOTORS COMPANY
  1. Install the black end of the tilt cable assembly to the steering column.
  2. Install the white end of the tilt cable assembly to the tilt drive motor assembly.
    3. Fig 2: View Of Potentiometer Housing, Tilt Drive Motor Assembly & Screws
    GM626489Courtesy of GENERAL MOTORS COMPANY
  3. Snap on the potentiometer housing. (1).
  4. Install the tilt drive motor assembly (2) to the steering column.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install 2 TORX® head screws (3) and tighten to 1.5 N.m (13 lb in).
    6. WARNING:

    Refer to SIR Inflator Module Coil Warning .

  6. Connect the connectors of the tilt drive motor assembly (2).
  7. Install the steering column into the vehicle. Refer to Steering Column Replacement (without JL7) .
  8. Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
  9. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals