Installation Procedure
- Install the upper steering column trim cover (1) to the closeout shroud (3).
- Install the upper trim cover (1) to the steering column.
- Install the retaining screw to the upper trim cover and tighten to 1.5 N.m (13 lb in).
- Install the Ignition lock cylinder.
- Install the lower steering column trim cover and ensure that the tabs (2) on the lower trim engage with the tabs on the upper trim cover. Snap the covers together.
- Connect the lower trim cover to the closeout shroud.
- Install the retaining screws to the lower trim cover and tighten to 3 N.m (27 lb in).
- Install the knee bolster. Refer to Knee Bolster Replacement .
- Install the steering wheel. Refer to Steering Wheel Replacement .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (With Side Post) , Battery Negative Cable Disconnection and Connection (With Top Post) .
- Enable the SIR system. Refer to SIR Disabling and Enabling .
CAUTION:
Refer to Fastener Caution .
CAUTION:
Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.