LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> STS AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Repair Instructions >> Driver or Passenger Seat Side Inflatable Restraint Module Replacement >> Removal Procedure

Removal Procedure

    WARNING:

    Refer to SIR Inflator Module Handling and Storage Warning .

    WARNING:

    Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

    • The seat cushion frame
    • The seat recliner, if equipped
    • The seat adjuster
    • The seat back frame

    Failure to do so may cause future personal injury.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
    2. NOTE:

    Removal of the right or the left inflatable restraint side impact module uses the same procedure.

  2. Move the seat to the full forward position.
  3. Remove the seat back panel. Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement .
    4. Fig 1: Locating Inflatable Restraint Side Impact Module Bracket Bolts
    GM792279Courtesy of GENERAL MOTORS COMPANY
  4. Remove the 2 bolts (1) from the inflatable restraint side impact module bracket.
  5. Remove the module from the seat.
  6. Remove the connector position assurance (CPA) from the module electrical connector.
    7. Fig 2: View Of Inflatable Restraint Side Impact Module Electrical Connector
    GM792283Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the electrical connector (1) from the module.
scientia non olet · About LEMON Manuals