LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> STS AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Brake Pressure Modulator Valve Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of BPMV
    GM1906553Courtesy of GENERAL MOTORS COMPANY
  1. Install the BPMV (1).
    2. Fig 2: Identifying BPMV Bolt
    GM1906552Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the BPMV bolt (1) and tighten to 11 N.m (97 lb in).
    3. Fig 3: Identifying RF Brake Pipe Fitting
    GM1906551Courtesy of GENERAL MOTORS COMPANY
  3. Connect the right front brake pipe fitting (1) and tighten to 20 N.m (15 lb ft).
    4. Fig 4: View of LR Brake Pipe Fitting
    GM1906549Courtesy of GENERAL MOTORS COMPANY
  4. Connect the left rear brake pipe fitting (1) and tighten to 20 N.m (15 lb ft).
    5. Fig 5: View of RR Brake Pipe Fitting
    GM1906547Courtesy of GENERAL MOTORS COMPANY
  5. Connect the right rear brake pipe fitting (1) and tighten to 20 N.m (15 lb ft).
    6. Fig 6: Identifying LF Brake Pipe Fitting
    GM1906546Courtesy of GENERAL MOTORS COMPANY
  6. Connect the left front brake pipe fitting (1) and tighten to 20 N.m (15 lb ft).
  7. Connect the EBCM electrical connector
  8. Position the washer solver container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (With CE4) , Windshield Washer Solvent Container Replacement (Without CE4) .
  9. Install the front air deflector shield. Refer to Front Air Deflector Replacement .
  10. Lower the vehicle.
    11. Fig 7: Identifying Primary BPMV Inlet Brake Pipe Fitting
    GM1906545Courtesy of GENERAL MOTORS COMPANY
  11. Connect the primary BPMV inlet brake pipe fitting (1) and tighten to 32 N.m (24 lb ft).
    12. Fig 8: View of Pressure Modulator Valve (BPMV) Inlet Brake Pipe Fitting
    GM1906544Courtesy of GENERAL MOTORS COMPANY
  12. Connect the secondary BPMV inlet brake pipe fitting (1) and tighten to 32 N.m (24 lb ft).
  13. Install the RH front compartment sight shield. Refer to Front Compartment Sight Shields Replacement .
  14. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) , Hydraulic Brake System Bleeding (Pressure) .
  15. Perform the Antilock Brake System Automated Bleed .
  16. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals