LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> STS AWD >> Repair and Diagnosis >> Body & Frame >> Fixed And MOVEABLE Windows >> Repair Instructions >> Front Side Door Window Regulator Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Front Door Window Regulator
    GM758981Courtesy of GENERAL MOTORS COMPANY
  1. Install the window regulator into the door.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the window regulator bolts (1, 2, 3, 4, 5) and tighten to 9 N.m (80 lb in).
  3. Remove the support from the window.
  4. Lower the window into the window regulator clamps.

    The window must be fully rearward into the window channel when it is seated in the window clamps.

  5. Connect the power window motor electrical connector.
    6. NOTE:

    Start the vehicle to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.

  6. Start the vehicle.
  7. Raise the window to the full up position. Tighten the window clamp nuts to 11 N.m (95 lb in).
  8. Inspect the window for proper operation and fit.
  9. Shut off the vehicle.
  10. Install the water deflector.
  11. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  12. The window motors need to be programmed/initialized whenever power is removed from the window motor. Refer to Window Motor Programming - Express Function .
scientia non olet · About LEMON Manuals