LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> Escalade EXT >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Suspension System >> Repair Instructions >> Rear Axle Upper Control Arm Replacement >> Installation Procedure

Installation Procedure

  1. Install the upper control arm.
    2. Fig 1: Upper Control Arm-To-Axle Bracket Retaining Nut And Bolt
    GM516271Courtesy of GENERAL MOTORS CORP.
  2. Install the upper control arm retaining bolt and nut to the axle bracket.
    3. Fig 2: Upper Control Arm-To-Frame Bracket Retaining Nut And Bolt
    GM516277Courtesy of GENERAL MOTORS CORP.
  3. Install the upper control arm retaining bolt and nut to the frame bracket.
    4. CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Do not tighten the nuts unless the suspension is at the curb height position.

  4. Tighten the upper control arm bolts to :
    • First Pass: 100 N.m (74 lb ft)
    • Final Pass: plus 55 degrees
  5. Connect the ESC sensor, if equipped. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side , or Electronic Suspension Rear Position Sensor Replacement - Right Side .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals