Removal Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Run the window to the full up position.
- Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Remove the water deflector.
- Tape the window in the full up position.
- Through the access holes in the inner door panel, loosen the window clamp nuts 4 revolutions.
- Connect the door trim panel wiring harness.
- Lower the window regulator 3/4 of the way down.
- Disconnect the electrical connector from the window regulator motor.
- Remove the window regulator bolts (1, 2, 3, 4, 5).
- Remove the window regulator from the door.