LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2011 >> DTS 4.6 6 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 4.6L - Repair Instructions >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Fuel Level Sensor Wiring Harness Electrical Connector
    GM1671971Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Always use the NEW seal provided with the sensor.

  1. Install the fuel tank pressure sensor.
  2. Connect the fuel level sensor wiring harness electrical connector (1) to the fuel tank pressure sensor.
    3. Fig 2: Identifying Fuel Sender Access Hole Cover
    GM1671970Courtesy of GENERAL MOTORS COMPANY
  3. Place the fuel sender access hole cover into position.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the fuel sender access hole cover bolts.

    Tighten 

    Tighten the bolts to 2 N.m (18 lb in).

  5. Install the rear compartment liner. Refer to Rear Compartment Liner Replacement .
scientia non olet · About LEMON Manuals