LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> Escalade EXT >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Suspension Control System - Suspension Damping >> Diagnostic Information and Procedures >> DTC C0696 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at all 4 suspension position sensors.
  2. Ignition ON, test for 4.75-5.25 volts between the 5 volt reference circuit terminal A and ground at each sensor connector.
    • If less than the specified range, test the 5 volt reference circuit for a short to ground or an open/high resistance. If all circuits test normal, replace the ESC module.
    • If greater than the specified range, test the 5 volt reference circuit for a short to voltage. If the circuit tests normal, replace the ESC module.
  3. Reinstall each sensor, one at a time, while verifying for 4.75-5.25 volts between the 5 volt reference circuit terminal A and ground of the last sensor connector to be connected.
    • If the voltage is out of the range when one of the 3 sensors are connected, test or replace the suspect suspension position sensor.
  4. Test or replace the last remaining suspect suspension position sensor.
scientia non olet · About LEMON Manuals