LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Upper, Lower Control Arms With Components
    GM65333Courtesy of GENERAL MOTORS CORP.
  1. Install steering knuckle to the upper control arm and the lower control arm. Refer to Upper Control Arm Replacement  and Lower Control Arm Replacement .
  2. Remove the jackstand.
  3. Install the steering linkage outer tie rod ball stud to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the stabilizer shaft link to the lower control arm.

    Tighten:  Tighten the stabilizer shaft link nut to 72 N.m (53 lb ft).

    5. Fig 2: View Of Wheel Speed Sensor Electrical Connectors
    GM919156Courtesy of GENERAL MOTORS CORP.
  5. Connect the wheel speed sensor electrical connector.
  6. Install the brake rotor and caliper. Refer to Front Brake Rotor Replacement and Front Brake Caliper Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
  9. Check the front wheel toe and adjust as necessary. Refer to Diagnostic Starting Point - Disc Brakes and Measuring Wheel Alignment .
scientia non olet · About LEMON Manuals