LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 463 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Stabilizer Shaft Insulator Clamps, Stabilizer Shaft Link & Nuts
    GM66493Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft, insulator clamps and bolts to the crossmember.
  2. Install the stabilizer shaft links to the stabilizer shaft.
    3. NOTE: Refer to Fastener Notice .
  3. Install the stabilizer shaft link nuts.

    Tighten:  Tighten the stabilizer shaft link nuts to 76 N.m (56 lb ft).

  4. Install the stabilizer shaft insulator clamps and bolts.

    Tighten:  Tighten the stabilizer shaft insulator clamp bolts to 58 N.m (43 lb ft).

  5. Install the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals