LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Brake Fluid Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Brake Fluid Pressure Sensor & Electrical Connector
    GM773022Courtesy of GENERAL MOTORS CORP.
  1. Install the brake fluid pressure sensor (2) to the EBCM (1).

    Tighten:  Tighten the brake fluid pressure sensor to 17 N.m (13 lb ft).

  2. Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
  3. Fill and bleed the hydraulic brake system. Refer to Master Cylinder Reservoir Filling and Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
  4. Perform the Auto Bleed Procedure. Refer to Anti-Lock Brake System Automated Bleed Procedure .
  5. Perform the Diagnostic System Check - Vehicle. Refer to Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals