LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of SIS & Mounting Fasteners
    GM751940Courtesy of GENERAL MOTORS CORP.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
  2. Install the SIS (1) to the center pillar.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the SIS mounting fasteners (2).

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

    4. Fig 2: View Of SIS CPA, Connector & SIS At Left Center Pillar
    GM751939Courtesy of GENERAL MOTORS CORP.
  4. Install the harness connector (2) to the SIS (3).
  5. Install the CPA (1) to the SIS harness connector (2).
  6. Install the center pillar trim. Refer to Center Pillar Garnish Molding Replacement in Interior Trim.
  7. Move the seat to the original position.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling  or SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals