Installation Procedure

WARNING: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

Fig 1: Lubricating Male Pipe End

Courtesy of GENERAL MOTORS CORP.

Fig 2: Connecting Fittings (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.
Apply a few drops of clean engine oil to the male pipe end.

Fig 3: View Of Quick-Connect Fitting

Courtesy of GENERAL MOTORS CORP.

Pull on both sides of the quick connect fitting in order to make sure the connection is secure.