LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> Steering >> Steering Linkage >> Repair Instructions >> Idler Arm Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
    2. Fig 1: View Of Idler Arm & Relay Rod
    GM1862657Courtesy of GENERAL MOTORS CORP.
    NOTE: Discard the idler arm nut.
  2. Remove the idler arm nut (3) from the idler arm (1).
  3. Separate the idler arm (1) from the relay rod (2).
    4. Fig 2: Removing Outer Tie Rod Assembly From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
  4. Remove the idler arm from the relay rod using puller J 24319-B  .
    5. Fig 3: View Of Idler Arm, Frame Bolts & Nuts
    GM340442Courtesy of GENERAL MOTORS CORP.
  5. Remove the idler arm bolts (3) and the nuts (1) at the vehicle frame.
  6. Remove the idler arm (2) from the vehicle.
scientia non olet · About LEMON Manuals