LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 336 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Nut & Studs
    GM1688057Courtesy of GENERAL MOTORS CORP.
  1. Position the wheel stud in the rear axle shaft.
  2. Using washers and a wheel nut, tighten the wheel nut until the wheel stud is firmly seated in the rear axle shaft.
  3. Remove the wheel nut and the washers.
  4. Install the rear axle hub assembly, if removed. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement .
  5. Install the brake rotor. Refer to Rear Brake Rotor Replacement (1500 Series) or Rear Brake Rotor Replacement (2500 Series) .
  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  7. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals