LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 336 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Control Arm, Retaining Nuts & Bolts
    GM545535Courtesy of GENERAL MOTORS CORP.
  1. Install the lower control arm.
  2. Install the lower control arm retaining bolts.
    3. CAUTION: Refer to Fastener Caution .
    NOTE: Do not tighten the bolts unless the suspension is at the ride height.
  3. Install the lower control arm retaining nut and tighten.
    • The lower control arm to frame bolts to 100 N.m (74 lb ft) plus 55 degrees.
    • The lower control arm to axle bolts to 100 N.m (74 lb ft) plus 55 degrees.
  4. Remove the rear axle support.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals