Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the leaf spring assembly to the vehicle.
- Install the front bolt and nuts but do not tighten.
- Install the rear leaf spring hanger to shackle nut and bolt.
- Install the rear leaf spring front nut and tighten to 170 N.m (125 lb ft) plus 48 degrees.
- Tighten the rear leaf spring hanger nut and bolt to 95 N.m (70 lb ft).
- Install the spring spacer, if equipped.
- Install the U-bolts.
- Raise the rear axle until it touches the leaf spring and applies light compression to the leaf spring.
- Install the anchor plate.
- Install and tighten the U-bolts in a criss-cross sequence to 100 N.m (74 lb ft) for the 1500 and 160 N.m (1184 lb ft) for the 2500.
- Install the fuel tank. Refer to Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank + E85) or Fuel Tank Replacement (2500 LWB - 4.35L (11.5 gal) Tank Rear) or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank + E85) or Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank Front) or Fuel Tank Replacement (1500 LWB - 117.3L (31 gal) Tank ) or Fuel Tank Replacement (1500 SWB - 98.4L (26 gal) Tank) .
- Install the trailer hitch, if equipped. Refer to Trailer Hitch Replacement .
- Remove the rear axle support.
- Remove the safety stands.
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution
.
NOTE:
Do not reuse the U-bolts.