Removal Procedure
WARNING: This page is about a different car, the 2010 GMC Yukon, 2010 Chevrolet Tahoe, and 2010 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- If equipped with 4 wheel drive (4WD), remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
- Disconnect the chassis wiring harness electrical connector (1) from the fuel pressure sensor (2).
- Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
- Remove the fuel pressure sensor (1) from the fuel line.
- Remove and discard the fuel pressure sensor O-ring seal (2).
Fig 1: View Of Chassis Wiring Harness Electrical Connector, Fuel Pressure Sensor, Fuel Pipe Bracket & Wiring Harness Clip