LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 283 (Power Steering System) >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Brake Booster Inlet Hose
    GM650858Courtesy of GENERAL MOTORS CORP.
    CAUTION: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation easier. Failure to follow these procedures could result in component damage.
  1. Install the power brake booster inlet hose (1) to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
    NOTE: Start both power brake booster inlet hose fittings by hand before finalizing torques.
  2. Connect the power brake booster inlet hose (1) to the power brake booster (2).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  3. Connect the power brake booster inlet hose (1) to the power steering pump (3).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  4. Clean any excess fluid from the vehicle and remove the drain pans.
  5. Install the engine shield. Refer to Engine Shield Replacement .
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals