LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Lighting System) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Pedal Position Sensor Electrical Connector, Brake Pedal Position Sensor & Bolts
    GM1687770Courtesy of GENERAL MOTORS CORP.
  1. Install the brake pedal position sensor (3) to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the brake pedal position sensor bolts (2) and tighten to 9 N.m (80 lb in).
  3. Connect the brake pedal position sensor electrical connector (1).
  4. Install the fuse block cover.
  5. Install the driver knee bolster. Refer to Knee Bolster Replacement (Cadillac) or Knee Bolster Replacement (Except Cadillac) .
scientia non olet · About LEMON Manuals