LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System >> Diagnostic Information and Procedures >> DTC B0967 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the I/P multifunction switch assembly.
  2. Test for less than 1.0 ohm between the appropriate ground circuit listed below and ground:
    • RPO X88/Z88 ground circuit terminal 3
    • RPO Z75 ground circuit terminal 5
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that the scan tool Park Assist Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the object alarm module.
  4. Ignition OFF, connect a 3A fused jumper wire between signal circuit terminal 2 and ground.
  5. Ignition ON, verify that the scan tool Park Assist Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the object alarm module.
  6. If all circuits test normal, test or replace the I/P multifunction switch assembly.
scientia non olet · About LEMON Manuals