LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> CTS V, Standard >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Repair Instructions >> Electronic Parking Brake Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Electronic Park Brake Module Bracket Bolts & Bracket
    GM2094784Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. If removed, install the electronic park brake module bracket bolts (1) and the bracket (2) and tighten the bolts to 9 N.m (80 lb in).
    2. Fig 2: Identifying Electronic Park Brake Module Assembly
    GM2094768Courtesy of GENERAL MOTORS CORP.
  2. Install the electronic park brake module assembly (1) to the rear frame assembly.
    3. Fig 3: Identifying Electronic Park Brake Module Bracket Bolts
    GM2094765Courtesy of GENERAL MOTORS CORP.
  3. Install the electronic park brake module bracket bolts (1) and tighten to 25 N.m (18 lb ft).
  4. Connect the electronic park brake module electrical connector.
    5. Fig 4: Identifying Park Brake Cable Nut
    GM2094760Courtesy of GENERAL MOTORS CORP.
  5. Inspect the O-ring seals on the spindle and the cable for damage and correct positioning and replace, if necessary.
  6. Install the park brake cable fitting to the spindle.

    Ensure the park brake cable fitting is engaged in the actuator in the spindle.

  7. Position the park brake cable nut to the spindle.
    8. NOTE: When installing the electronic park brake cable nut to the electronic park brake module spindle, hold the spindle housing securely to avoid distorting the housing.
  8. Install the park brake cable nut (1) to the electronic park brake module spindle by rotating the nut clockwise and tighten to 6 N.m (53 lb in).
    9. NOTE: When installing the rear frame assembly, ensure the park brake cable does not become trapped between the frame mount and the vehicle body.
    Fig 5: Identifying Rear Brake Hose Assembly Bracket Nuts
    GM2094759Courtesy of GENERAL MOTORS CORP.
  9. Install the rear frame assembly. Refer to Rear Frame Replacement .
  10. Install the rear brake hose assembly bracket to the studs.
  11. Install the nuts (1) to the rear brake hose assembly bracket and tighten to 10 N.m (89 lb in).
    12. Fig 6: Identifying Bolt Securing Fuel & Brake Pipe Bundle
    GM2094756Courtesy of GENERAL MOTORS CORP.
  12. Install the bolt (1) securing the fuel and brake pipe bundle to the vehicle underbody and tighten to 10 N.m (89 lb in).
    13. Fig 7: Identifying Frame Rail Clips
    GM2094753Courtesy of GENERAL MOTORS CORP.
  13. Install the fuel and brake pipe bundle to the frame rail clips (1).
  14. Install the fuel and brake pipe bundle retainer (2) to the vehicle underbody.
  15. Install the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  16. Lower the vehicle.
  17. Set the electric park brake cable tension. Refer to Parking Brake Cable Adjuster Enabling (Electric Park Brake) .
scientia non olet · About LEMON Manuals