Installation Procedure
- Install the window down into the door.
- Locate the window into the 2 window regulator clamps.
- Start the vehicle.
- Using the power window switch, raise the window to the fully closed position. Tighten the window clamp nuts to 11 N.m (98 lb in).
- Install the window inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
- Inspect for proper window operation and a tight seal.
- Shut off the vehicle.
- Install the water deflector.
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
NOTE:
The window regulator should be at least 1/2 way down before installing the window.
NOTE:
Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
CAUTION:
Refer to Fastener Caution
.