Pedestrian Impact Detection Sensor Replacement - Rear Upper Beam

Fig 1: Identifying Pedestrian Impact Detection Sensor - Rear Upper Beam

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable the pedestrian impact detection system. Refer to Pedestrian Impact Detection System Disabling and Enabling . Remove the front air deflector. Refer to Front Air Deflector Replacement .
1	Pedestrian Impact Detection Sensor CAUTION: Refer to Fastener Caution . Procedure Disconnect the electrical connector. Loosen the sensor integral bolt. Tip: The bolt is an integral part of the sensor and should remain with the sensor. Tighten: 10 N.m (89 lb in)

Callout

Component Name

Preliminary Procedures

Disable the pedestrian impact detection system. Refer to Pedestrian Impact Detection System Disabling and Enabling .
Remove the front air deflector. Refer to Front Air Deflector Replacement .

Pedestrian Impact Detection Sensor

CAUTION: Refer to Fastener Caution .

Procedure

Tip: The bolt is an integral part of the sensor and should remain with the sensor.

Tighten: 10 N.m (89 lb in)