Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Route the mirror wiring harness through the hole in the mirror patch.

Fig 1: View Of Power Mirror
Courtesy of GENERAL MOTORS CORP.
Seat the grommet (2) into the hole in the door frame.
Install the mirror (1) into the door frame.
Install the mirror fasteners in the following sequence:
Tighten:
1. Tighten the top mirror fastener (4) to 9 N.m (80 lb in).
2. Tighten the forward mirror fastener (5) to 9 N.m (80 lb in).
3. Tighten the rear, lower mirror fastener (6) to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice .
Connect the power mirror electrical connector (3).
Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .