Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Intermediate Brake Hose Assembly & Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.

Install the intermediate brake hose assembly (2) to the mounting studs.

NOTE: Refer to Fastener Notice .

Install the intermediate brake hose assembly mounting nuts (1) to the mounting studs.
Tighten: Tighten the intermediate brake hose assembly mounting nuts to 14 N.m (10 lb ft).
Remove the caps and/or plugs from the (2) (BPMV) to intermediate brake pipe fittings.
Connect the (2) (BMPV) brake pipe fittings to the intermediate brake hose assembly.
Remove the rubber plug from the brake hose to caliper bolt hole of the brake caliper.

Fig 2: View Of Brake Hose Banjo Fitting

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Install NEW copper brake hose gaskets.

Assemble the brake hose (2), the NEW copper brake hose gaskets (3), and the brake hose bolt (4) to the brake hose (2).
Install the brake hose (2) to caliper bolt (4) to the brake caliper (1).
Tighten: Tighten the brake hose to caliper bolt to 50 N.m (37 lb ft).

Fig 3: Disconnecting/Reconnecting Brake Line Fitting

Courtesy of GENERAL MOTORS CORP.

Remove the rubber cap and/or plug from the crossover brake pipe end.
Using a flat-bladed tool, install the brake hose retainer (2) to the rear frame assembly.
Connect the crossover brake pipe fitting (1) to the intermediate brake hose assembly (3).
Tighten: Tighten the brake pipe fittings to 18 N.m (13 lb ft).
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) or Hydraulic Brake System Bleeding (Manual) .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.